Selling a Fairclough valve cover fitting. Asking $20. Pm me if you are interested. Thanks!

 

Bump

 

ttt

 

I do not think that is the -6 STM fitting. It needs to be machined smooth like the -10 Fairclough fitting. Just letting you know.
I have the STM -6 an fitting on a shelf and its looks smooth like the -10 (but smaller, obviously).

 

Looks like a mistake, thanks

 

No worries, good luck with the sale.
For the buyers, I use only the -10AN fitting on my setup. I use it in the passenger side of the VC (PCV side) and routed to a catch can. I re-routed the PCV to the driver side of the valve cover (stock port) by just using a longer hose from the PCV fitting to the valve cover.
This enables you to keep the PCV while opening up the venting on the other side using the -10 AN fitting. No issues, very cost effective solution.
Hope this helps you sell the piece.

 

that -6 is a stm fitting for the front of the block I have the same one