Notices
For Sale - Part Outs Parting out your car? Place it in here.
Mark this thread as Unsold

FS[West]: Evo IV Parts

Thread Tools
 
Search this Thread
 
Old Aug 3, 2015 | 10:55 AM
  #1  
EvoIV_97's Avatar
Thread Starter
Newbie
Veteran: Air Force
iTrader: (2)
 
Joined: Nov 2012
Posts: 21
Likes: 1
From: California
Evo IV Parts

I have most of an Evo IV up for sale. I shipped the parts back in hopes of doing a Mirage conversion but that will be too large of a project, and have purchased an 8 instead. I'm in Northern California and looking for $4000 obo for all of it. Just about everything is still wrapped up or in a box, let me know if you want pictures of something specific. Some of the stuff is at my house and I can get you a picture same day, other stuff is in my parents garage and will take a week or two for pictures or shipping.

Here's a list of what I have, I'll keep adding prices as I try to figure out what it's worth. Everything is obo

All doors - very little wear/ dings $200 each
Hood - Sold
Trunk with spoiler - a few light scratches, dime sized bump $400
Carpet RHD - Good $100
Dash RHD - Good
Center console RHD - Good
Steering wheel - Sold
Rear seats - Excellent $100
Ralliart Floor/Trunk mats RHD - Sold
Interior plastic trim - Good Make an offer on individual pieces
Front subframe RHD $150
Front crossmember $75
Front LCAs $50 each
EVO VI (17x7) stock rims powdercoated mat black with newish tires (very little wear but 2yrs old). one was lightly curbed (the week I got them coated!) and the others have some damage from the move $500
Front bumper - Sold
Rear bumper - Sold
Rear bumper - two 1 inch cuts $150
Side skirts - small scrapes $75
Aluminum radiator - Unknown brand, less than 3000 miles $100
Stock intercooler pipes - good $60
oil cooler - good but they were small on the IV's $40
Engine harness - Needs small repairs(new cam sensor plug, new alternator cable) $150
Dash harness RHD - Repinned for EVO 7/8 ECU $150
EVO 4 ECU $60
EVO 7 ECU $150
EVO 4 injectors 510cc? $40
Evo V? 300 km/h gauge cluster (repair done to circuit) $500
Aftermarket cluster surround with boost & oil pressure - Bar not psi $100
Fender braces - light surface pitting $50
Front subframe brace - light rust $50
Front aluminium strut brace - light corrosion $40
Trunk floor aluminium brace - good $40
LHD headlights with corner lamps- Excellent $150
Taillights - Excellent $30
Automatic A/C & Heater unit - Excellent
All electronics (AYC, Airbags, ect) - Working with a few spares
Driveshaft - Good $250
Full 2.5" exhaust (2.25" downpipe)- light rust on most pipes, muffler and tip still look great $150




Attached Thumbnails Evo IV Parts-20150803_102526.jpg   Evo IV Parts-20150803_103000.jpg   Evo IV Parts-20150803_100837.jpg   Evo IV Parts-20150803_153526.jpg   Evo IV Parts-20150803_102031.jpg  


Last edited by EvoIV_97; Oct 19, 2016 at 09:54 AM. Reason: Items sold
Old Aug 5, 2015 | 08:39 PM
  #2  
EvoIV_97's Avatar
Thread Starter
Newbie
Veteran: Air Force
iTrader: (2)
 
Joined: Nov 2012
Posts: 21
Likes: 1
From: California
bump
Old Aug 8, 2015 | 09:47 PM
  #3  
EvoIV_97's Avatar
Thread Starter
Newbie
Veteran: Air Force
iTrader: (2)
 
Joined: Nov 2012
Posts: 21
Likes: 1
From: California
I'm going to start selling parts after next week if no one wants the whole lot
Old Aug 15, 2015 | 01:13 PM
  #4  
EvoIV_97's Avatar
Thread Starter
Newbie
Veteran: Air Force
iTrader: (2)
 
Joined: Nov 2012
Posts: 21
Likes: 1
From: California
Nobody wants the whole parts list so I'll be unpacking everything next week and getting pictures and prices up for everything.. I'm not looking forward to this haha
Old Dec 8, 2015 | 12:10 PM
  #5  
nemsin's Avatar
Evolved Member
iTrader: (19)
 
Joined: Feb 2008
Posts: 2,562
Likes: 50
From: PNW
These parts still available?
Old Dec 29, 2015 | 05:41 PM
  #6  
chowetime's Avatar
Evolved Member
iTrader: (16)
 
Joined: Apr 2004
Posts: 1,033
Likes: 0
From: Western Australia
interested in the Gauge cluster...
Old May 2, 2016 | 09:37 PM
  #7  
EvoIV_97's Avatar
Thread Starter
Newbie
Veteran: Air Force
iTrader: (2)
 
Joined: Nov 2012
Posts: 21
Likes: 1
From: California
I'd like to apologize to everyone who wanted parts, I know I disappeared there for a while. Between work, school, and the debate between building this or buying an 8 (I finally bought an 8) I haven't had the time or desire to be on here. But I am back and ready to sell now and can get pictures on about half the parts same day, the other half within about a week or two (on request, I have to go to my parents garage to unbox them). I'll start adding prices on to all the individual items as well. Again, sorry for disappearing on all the people wanting parts.
Old May 3, 2016 | 07:18 AM
  #8  
chowetime's Avatar
Evolved Member
iTrader: (16)
 
Joined: Apr 2004
Posts: 1,033
Likes: 0
From: Western Australia
All good I am still very keen on the gauge cluster.
Old May 3, 2016 | 09:21 AM
  #9  
EvoIV_97's Avatar
Thread Starter
Newbie
Veteran: Air Force
iTrader: (2)
 
Joined: Nov 2012
Posts: 21
Likes: 1
From: California
It has been repaired on the circuit board, but still works perfectly. I'll throw a picture up tonight when I get off work.

Originally Posted by chowetime
All good I am still very keen on the gauge cluster.
Old May 3, 2016 | 07:26 PM
  #10  
EvoIV_97's Avatar
Thread Starter
Newbie
Veteran: Air Force
iTrader: (2)
 
Joined: Nov 2012
Posts: 21
Likes: 1
From: California
Here's the back of the gauge cluster
Originally Posted by chowetime
All good I am still very keen on the gauge cluster.
Attached Thumbnails Evo IV Parts-img_0297.jpg  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Boltz.
Midwest Region
11
Aug 25, 2012 05:41 PM
PSIbabi21
Midwest Region
3
Aug 30, 2006 10:16 AM
Rollaway
Private 'Evo 1 - 9' For Sale / Wanted
9
Jul 29, 2004 07:33 AM




All times are GMT -7. The time now is 11:05 AM.