Harness bar pics of bar from EvoGR8 group buy
Thread Starter
Newbie
Joined: Jun 2006
Posts: 24
Likes: 0
From: Sunny SD
Harness bar pics of bar from EvoGR8 group buy
Since I'm a noob and can't post in the for sale forum yet so instead I figured here would be a good spot
Here's some pics of the bar EVOGR8 is doing the group buy for. I went ahead and picked up this bar from the manufacturer since i'm in san diego and only 10 minutes from the guy.
Shows how high the bar is from the back
upper bar mount welds
lower bar ends
upper bar end welds
seat belt mount welds
This is about how upright your seat needs to be for it to go all the way back
I'd say the welds are a B+, A-, not amazing, but they get the job done, it's primered but not painted (ready for powder coat. Comes with bolts for the bar to lower bar, and extended bolts for the upper seat belt, you reuse the lower seat belt mount bolt. You do need to be careful when putting it in not to scratch up your plastic at the upper mount, two people make the job easier, they suggest using cardboard between the plastic and metal temporarily until you have all the bolts in. I'd say the fit is really good, nice and snug, no gaps or anything. The harnesses will mount up about inch to inch and a half below the seat holes if you sit reasonably upright like i do. These are lower quality images I can send you bigger ones if you want. Overall
for getting the job done for less money
Here's some pics of the bar EVOGR8 is doing the group buy for. I went ahead and picked up this bar from the manufacturer since i'm in san diego and only 10 minutes from the guy.
Shows how high the bar is from the back
upper bar mount welds
lower bar ends
upper bar end welds
seat belt mount welds
This is about how upright your seat needs to be for it to go all the way back
I'd say the welds are a B+, A-, not amazing, but they get the job done, it's primered but not painted (ready for powder coat. Comes with bolts for the bar to lower bar, and extended bolts for the upper seat belt, you reuse the lower seat belt mount bolt. You do need to be careful when putting it in not to scratch up your plastic at the upper mount, two people make the job easier, they suggest using cardboard between the plastic and metal temporarily until you have all the bolts in. I'd say the fit is really good, nice and snug, no gaps or anything. The harnesses will mount up about inch to inch and a half below the seat holes if you sit reasonably upright like i do. These are lower quality images I can send you bigger ones if you want. Overall
for getting the job done for less money
Last edited by kw273; Aug 31, 2006 at 04:52 PM.
Thanks for checking these people out for us!
This is the thread to the GB.
https://www.evolutionm.net/forums/sh...d.php?t=219832
This is the thread to the GB.
https://www.evolutionm.net/forums/sh...d.php?t=219832
Thread Starter
Newbie
Joined: Jun 2006
Posts: 24
Likes: 0
From: Sunny SD
Well, i didn't make em, i just bought it. Although I thought the same at first, but then I realized that with the heim, you'd need new bolts whereas with the flat, you just take out one of the washers from the old seatbelt bolt and you're good...
