Pegasus will send the tank tools to you as soon as he received and finished with it. pm him your address.

In a few days, it should arrive at his place.

 

I could use the 22mm for the tank since i already ruined 1 tank by useing some kind of bit the guy at the hardware store gave me. Was not 22mm. Also how do you go about taping the IC pipe? is thier some kinda bung you guys are welding in or what? If anyone could give me a link to where i can buy either of these, i would like to buy them and would be willing to pass them on also.

 

I finished with the tools tonight. I should be able to ship out tomorrow to Blue SI. Thanks again Richard!

 

Tools were shipped out to Blue Si today via UPS.

 

I couldn't wait for them and bought a set of my own. Unfortunately I did not inform Pegasus before he sent them to me.

If anyone needs them, please let me know and I will ship them to you the moment I get them from UPS.

 

PM'd

 

Take a look at this thread.
http://www.srtforums.com/forums/showthread.php?t=318464

Theres some drills and taps floating around (I'm currently out of them), The big thing with using these is to think and measure a couple of times before actually drilling anything.

 

whos up next? I just got the stuff today, plan on using it tomorrow and can get it sent off by Saturday.

 

F.Y.I. I was at the hardware store on Saturday and bought a standard (US) stepped bit. Looks kind of like the one in the middle of image in this linked page
http://www.harborfreight.com/cpi/cta...emnumber=91616

I should be done with this by this coming weekend. If any one would like to use it because the other one is tied up let me know.

Heres a link to a conversion chart
http://www.globaljewelry.com/mm2inchconverter.htm
obviously it's not a hundred 100% accurate but I think it will work and I did use a standard bit like this for an older setup I had without a problem....just need to be careful not to remove to much.

EDIT 09-24-07 : the bit I mentioned here sucks = very hard to control drilling the correct size = never mind.

 

Anyone have any ideas where I could get the 1/8 tap? PM me with the info. I would like to install my kit this weekend if possible.

 

Hey Guys,
Is this tap still floating around, I would like to use it?

 

I need this tool as well. Please PM me whoever has it. THanks!

 

I have one more left. It appeared the last user did not put "subscribe on" . PM me your address.

I only have the hole cutter left.

 

I'll get in touch with the last guy, he lives in Hawaii too.

 

Richard...
are you recieving my PMs...?