My G35 TT Port Injection Pics
Thread Starter
Newbie
Joined: Nov 2008
Posts: 10
Likes: 0
From: Los Angeles
My G35 TT Port Injection Pics
Hello All,
I have been helped by this community and Richard with my Aquamist HFS5 planning...and wanted to share some of the install pictures. Hope you enjoy it, even though it's not from an Evolution. I just find these forums the most informative as far as WI goes, and wanted to be a part of it.
I have been helped by this community and Richard with my Aquamist HFS5 planning...and wanted to share some of the install pictures. Hope you enjoy it, even though it's not from an Evolution. I just find these forums the most informative as far as WI goes, and wanted to be a part of it.
Last edited by GurgenPB; Dec 13, 2008 at 12:36 AM.
Thread Starter
Newbie
Joined: Nov 2008
Posts: 10
Likes: 0
From: Los Angeles
They are all 0.5 mm. Going for high water to fuel ratio. I have a MoTeC controlling the hsv duty cycle, so I'm not locked in and can vary the amount of water in my table.
This is a really nice looking installation of port injection.
It won't be too difficult to put a y-piece on the other side of the rail in case some delay is experienced by the end jets. This is due to vacuum pulses are commutating between jets freely.
It won't be too difficult to put a y-piece on the other side of the rail in case some delay is experienced by the end jets. This is due to vacuum pulses are commutating between jets freely.
Last edited by Richard L; Dec 13, 2008 at 01:49 PM.
Thread
Thread Starter
Forum
Replies
Last Post
GSX_TO_EVO
Evo Tires / Wheels / Brakes / Suspension
2
Apr 5, 2017 06:55 PM
MattyBoyMR
For Sale/WTB - Engine / Drivetrain / Power
0
Aug 29, 2015 03:54 PM
Evopower88
For Sale/WTB - Engine / Drivetrain / Power
0
Apr 23, 2015 08:42 AM
