Hey guys have a few questions reguarding using meth. I dont have e85 in my area so i have a meth kit imma going to run in my evo 9. My mods are ported polished exhaust manifold and intake manifold. Full TBE airfuel ratio meter ets upper and lower intercooler gonna get 70mm tb and plate for intake manifold. Ets cold air intake walbro fuel pump. Aem meth controller with low level sensor and sight. Imma alsor running a manual boost controller. Now from what i have read i will need bigger fuel injectors what would anyone recommend i was looking at 880s or 1000s as i was going to maybe upgrade my turbo to an fp green. With no turbo upgrade i was looking to hit 400 hp. What size jet should i run with this setup. I am using stock evo 9 cams any help would be great

 

I ran two 1mm. A .8mm and .8 mm would be good. The more meth you run the less injector you will need. Just make sure your failsafe is set up properly. I like a lot of meth though and ran 100%.If running 50/50 you probably don't need as much.

 

ok guys looking to hook up fail safe so i dont blow my motor how is that wired in to the evo 9 ecu

 

so no ome has done this come on guys give out sime help with this

 

Sorry man, I used aquamist

 

 

im using aem methanol kit. size depending on your tuner