EvolutionM - Mitsubishi Lancer and Lancer Evolution Community
0 2020/11/15 06:44:16
0 2020/11/15 06:41:54
0 2020/11/14 19:37:51
0 2020/11/14 19:37:46
0 2020/11/14 19:37:41
0 2018/12/29 12:57:59
0 2018/12/29 12:57:58
With heat shield. Runs good!
With heat shield. Runs good!
0 2018/01/16 18:49:50
All put together!
All put together!
0 2018/01/16 18:49:38
All installed. Almost ready to drive
All installed. Almost ready to drive
0 2018/01/15 19:28:47
Mishimoto radiator, assembly the fan onto it
Mishimoto radiator, assembly the fan onto it
0 2018/01/15 19:28:33
Ceramic coating
Ceramic coating
0 2018/01/15 19:28:22
Ceramic coating paint
Ceramic coating paint
0 2018/01/15 19:28:13
Primed with high temp paint
Primed with high temp paint
0 2018/01/15 19:28:04
FP manifold with new hardware
FP manifold with new hardware
0 2018/01/15 19:27:57
Putting it back together
Putting it back together
0 2018/01/15 19:27:45
Freshened up cylinder head installed with s1 cams
Freshened up cylinder head installed with s1 cams
0 2018/01/15 19:27:40
Evo pushed out of the garage to clean the engine
Evo pushed out of the garage to clean the engine
0 2018/01/13 15:25:19
Motor all cleaned up
Motor all cleaned up
0 2018/01/13 15:25:15
Underside of the head
Underside of the head
0 2018/01/13 15:24:59
Head back from the machine shop, with the evo 9 valves and new valve seals. Decked, hot tanked and cleaned.
Head back from the machine shop, with the evo 9 valves and new valve seals. Decked, hot tanked and cleaned.
0 2018/01/13 15:24:49
Reassembled
Reassembled
0 2018/01/13 15:24:38
Fan shroud repainted, it was all rusty
Fan shroud repainted, it was all rusty
0 2018/01/13 15:24:17
New coil cover on the painted valve cover
New coil cover on the painted valve cover
0 2018/01/13 15:24:06
Side of the head was super dirty
Side of the head was super dirty
0 2018/01/13 15:17:17
Old valves, pretty dirty
Old valves, pretty dirty
0 2018/01/13 15:17:12
Races on the head
Races on the head
0 2018/01/13 15:17:07
Reassembled
Reassembled
0 2018/01/13 15:17:05
Replace bearing body onto shaft with new snap ring
Replace bearing body onto shaft with new snap ring
0 2018/01/13 15:17:03
Slide new boot on with clamp in place
Slide new boot on with clamp in place
0 2018/01/13 15:17:00
Wipe down the shaft
Wipe down the shaft
0 2018/01/13 15:16:56
Bearings slid off
Bearings slid off
0 2018/01/13 15:16:46
Remove snap ring from CV bearing body
Remove snap ring from CV bearing body
0 2018/01/13 15:16:44
0 2018/01/13 15:16:41
Redoing the inner CV boots. They were torn and low on grease. I think this is was also caused my alternator to go bad, it was covered in grease.
Redoing the inner CV boots. They were torn and low on grease. I think this is was also caused my alternator to go bad, it was covered in grease.
0 2018/01/13 15:16:39
Got some evo 9 valves in to replace mine
Got some evo 9 valves in to replace mine
0 2018/01/13 15:16:37
Pistons before i cleaned them
Pistons before i cleaned them
0 2018/01/13 15:12:33
Closer pic of the cams, they turned out not being stock. They are HKS cams
Closer pic of the cams, they turned out not being stock. They are HKS cams
0 2018/01/13 15:12:31
Newer steering wheel i got on eBay
Newer steering wheel i got on eBay
0 2018/01/13 15:12:27
Cleaning the Pistons
Cleaning the Pistons
0 2018/01/13 15:12:25