Creamo3

iTrader: (48)

I'm looking to eliminate the banjo bolt that feeds the turbo from the head with a 90-degree fitting. The only problem is that I can't seem to find the right fitting and was wondering if anyone knows where i can order one at. The fitting would look similar to this, but would thread into the head and accept a -4AN oil line. I believe the threads for the oil feed into the head are 10mm x 1.25 pitch




Worst case I'll order one of these that is a straight fitting, but I prefer a 90-degree if possible:http://www.atpturbo.com/Merchant2/me..._Code=ATP-OIL1


Any help would be appreciated

apagan01

iTrader: (299)

i like this, hoepfully you can make this work.

ExViTermini

iTrader: (25)

I would have figured that atp would have the fitting...at one time I remember they did, as I used one on a friends car...

Creamo3

iTrader: (48)

I was surprised they didn't have it either; I know the fitting exists as I have seen it on some turbo setups on here. Just need to find where to buy it.

Creamo3

iTrader: (48)

ATP got back to me w/ a solution that will do what I'm looking for. They said to combine these two parts and I will be able to have a 90-degree for my oil feed. This may help somebody else looking to eliminate the banjo bolt w/ crush washers on their setup.

Combine this:http://www.atpturbo.com/Merchant2/me..._Code=ATP-OIL1


and this: http://www.atpturbo.com/Merchant2/me...egory_Code=BCS

ExViTermini

iTrader: (25)

I would just use a banjo fitting that has an -AN thread on the end of it, tis what I did and its worked well forever. I actually have a 3 or 4 still around if you want it.

Creamo3

iTrader: (48)

I'm actually trying to avoid the banjo fitting as it requires the use of crush washers and I'm trying to avoid that setup. I appreciate the offer though

CBRD

iTrader: (60)

they arent M10x1.25 i dont believe.. but i have to check...

you can find somethinig nicer than brass!

cb

Creamo3

iTrader: (48)

Show me the way and I'll be all over it

AF-Evo8

iTrader: (113)

if you can find out thread/pitch this may work
http://www.streettunedmotorsports.co...90_adaptor.htm

AF-Evo8

iTrader: (113)

http://www.streettunedmotorsports.co...y_fittings.htm its towards the bottom they have a few different thread sizes

DIDYSIS

iTrader: (18)

its a 10x1.25 call your local hose shop and they can get you everything for the best prices,. thats what i did or you can order the parts from someone like

http://www.maperformance.com/evo-vii...s-accessories/

RoadSpike

iTrader: (5)

Edit:

Didn't see your not on the stock turbo.

The stock fittings are 10mm and 12mm for the head and turbo respectively.