This will be a rendering on the project lip kit im making out of polyurethane. Sorry i can only show the front lip. Sides & Rear lip will be showed @ the SEMA show this year. NOTE: Picture is just an example. Lip will be smoothed and worked on and more fiberglass added against the fogs and side view of bumper. So if you see some cracks, bondo,paint etc. thats because its a rendering on the master copy mould. So please no comment back on it needs 2 be fixed. Thank you and enjoy.

 

looks good. gives it more of a droped look.

 

Where did you get those fogs?

 

Wanna make a few of these bad boys and sell em? I want to see the finished product, I assume the front won't be sagging like in the pics.

 

Im not sure if your looking for opinions on this with this thread posting but im gonna give you mine. From what it looks like.. The further towards the center of the car the lip goes the lower it gets. Not a big fan of the drop being that drastic. The style of the lip is good (just like RMR type 1).

 

looks like u need body work and paint work!!

 

the way it drops in the middle... it makes it looks as if its falling off the car or something haha

I'd prefer something even from side to side. Props though for going your own route

 

thanks 4 the comments back... "needs body work?" who gives a damn especially when i dont even drive this car @ all. The front lip is still getting worked on since it was just a rendering. The sides of the lip where it dips down, will "NOT" look like that, i havent updated on the pics. yet. I'm blending it in w/ the lower pattern and shape of bumper.

 

you should cut out the center part a little more, where the radiator is at, if possible

 

any update on this? lol