boost gauge help
Jul 21, 2009, 06:09 PM
#1
Evolved Member
Thread Starter
iTrader: (1)
Join Date: Apr 2009
Location: Ohio
Posts: 617
Likes: 0
Received 0 Likes
on
0 Posts
boost gauge help
I'm looking to install a boost gauge on my RA. was wondering how people who've done it got through the firewall and if there were any suggestions on a single a pillar pod. thanks for the help!
Jul 23, 2009, 01:13 AM
#3
Evolving Member
Join Date: Aug 2006
Location: I'm Canadian living and working in Dubai/Kuwait/Bahrain
Posts: 499
Likes: 0
Received 1 Like
on
1 Post
All you need to do is get in on the passenger side and remove the plastic that is under the glovebox. Once that is done peel back the carpet a little and you will see a place where there is a wire loom comming in from the engine bay. Get yourself a coat hanger and pass it through so it goes into the engine bay side. Either from under or on top depending where you have more clearance tape the line to the coat hanger and pull it through into the cockpit.
If its an electrical line your running it will be easy, if your running a mechanical boost gauge and your running the boost/vacuum line then spray some wd-40 on the line so it slides through the rubber grommet more easily.
If its an electrical line your running it will be easy, if your running a mechanical boost gauge and your running the boost/vacuum line then spray some wd-40 on the line so it slides through the rubber grommet more easily.
