EvolutionM - Mitsubishi Lancer and Lancer Evolution Community

Notices

gauge install

Thread Tools
 
Search this Thread
 
Old May 7, 2010 | 04:34 PM
Share
  #1  
SOG RA's Avatar
SOG RA
Thread Starter
Evolved Member
iTrader: (7)
 
Joined: Apr 2010
Posts: 735
Likes: 0
From: Rhode Island
gauge install
Hey guys,
Anyone install a pillar pod setup in their RA? How did you route wires, vacuum tube for boost etc? Anything would help.
Reply
0
Old May 7, 2010 | 11:57 PM
Share
  #2  
tjac357's Avatar
tjac357
Evolved Member
iTrader: (1)
 
Joined: Apr 2009
Posts: 617
Likes: 0
From: Ohio
What I used to help me:
https://www.evolutionm.net/forums/ev...lean-hell.html
Reply
0
Old May 8, 2010 | 12:08 AM
Share
  #3  
SOG RA's Avatar
SOG RA
Thread Starter
Evolved Member
iTrader: (7)
 
Joined: Apr 2010
Posts: 735
Likes: 0
From: Rhode Island
So you used an autometer, not a standalone and everything worked the same? Thanks for the link man.
Reply
0
Old May 8, 2010 | 09:03 AM
Share
  #4  
tjac357's Avatar
tjac357
Evolved Member
iTrader: (1)
 
Joined: Apr 2009
Posts: 617
Likes: 0
From: Ohio
I have the nexus line on my ralliart. Hooked the vac tube up to the line of the BOV, mounted the sensor in the fender, and the receiver behind the dash. Connected everything and it works.
Reply
0
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
JDP RA Lip install, remove bumper?
butters149
Evo X Show / Shine
3
Mar 21, 2014 09:18 PM
RA Rear Tow Hook Installed
MeToo
09+ Ralliart How-To/Installations
4
Jun 7, 2013 06:17 AM
Under drive pulley
kslater
04-06 Ralliart Engine/Drivetrain
13
Nov 20, 2012 06:05 AM
AEM UEGO Wideband
Jasoob
09+ Ralliart How-To/Installations
6
Apr 20, 2011 02:04 PM
ROAD/RACE- HID Headlight Conversion
ROCK
Lancer Vendor Classifieds
86
Dec 18, 2005 03:20 PM
Back to Subforum
09+ Ralliart How-To/Installations
View Next Unread
License plate install




Advanced Search

All times are GMT -7. The time now is 09:45 AM.