I have a Cobb 3-port sitting in my room and would like to know how to install it so I can run the stage 3 maps. Thank you very much.

 

Dood it's super easy. There are a plethora of how to threads on here. Just make sure you get ports 1 and 3 right.

 

I did a search and nothing came up on how to install it.

 

Just let your tuner/shop do it since you'll need a tune after installation.

 

http://www.cobbtuning.com/v/vspfiles...structions.pdf

 

looks like he has an AP.

 

I found a install page on Cobb's website. Thank you everyone for the help! Greatly appreciate it!

 

I seen it says using an off the shelf tune will result in overboosting, does that mean the ots maps for the accesstuner wont work??

 

Cobb's v3 maps for the Ralliart make use of the 3-port without need for a custom tune.

 

cool so I can use the 3port and access tuner without worrying of over boostin??

 

Just download the new maps and load them on your AP. AccessTuner has nothing to do with this.

 

Right on thanks for the info im kinda learning as I go

 

I just finished installing the 3port BCS this weekend. Stg 2 map feels more responsive

with regards to the install...the hardest part was removing the vacuum hose off the wastegate. The wastegate sits in a very hard to reach place and is a pain to grab the metal clip holding the hose onto the wastegate nipple.

In terms of instructions the one Cobb posted are good enough to get install done.