In the start-up calibration, the coolant temperature sensor table is completely different than the mitsubishi(ALL) settings in the wizard. Which one should I trust? Are the start-up calibrations configured correctly?

 

Bump, anyone know?

 

I have always used the Mitsubishi All calibration but I can't contend if it is accurate or not. You have brought up a very good point I am sure several people aren't aware of this, hopefully Jason Siebels will chime in and verify. He is from AEM and on the board.

 

Bump for Jason!

 

If you are talking about v1.19, I noticed the same thing when setting up an EVO. You need to change it to the right coolant temp sensor.