When sitting at idle, my engine load is about 36 perce. I have the aem ems with the 5 bar map. Does anyone think they know what the problem may be?

 

anybody?

 

do u have the 5 bar map sensor selected ? Setup->Sensors->manifold pressure sensor--> wizard.

-TJ

 

yeah, the 5 bar map was selected..

 

I would have to look at my MAP.....I run the same sensor (5 Bar) and getting the idle right is a little bit tricky due to the sensor only having two lines to tune for in vaccum. Maybe later today when I get back from auto-xing I will go out and hook my desktop up to my car and pull it out.

 

fixed it.. thanks all

 

what did you do too fix it? this is a community, help others!

 

it was reading under percentage, so I just changed the settings to PSI..