I had my new clutch instal and my acd was bled. Now when i start the vehicle within 1min all three acd lights turn on. being the idiot i am i took the car to the dealership, but they could not do anything due to the AEM. their laptop was not communicating with the AEM. i was wondering if there is a way to fix the light with the AEM or some people has had the similar problem.

 

sounds like you still have air in the line for the acd. if it was fine before and after the clutch swap you had the problem, i would start there

 

hmmmm that is not good... because the dealerschip uses MUT for power-up the pump to bleed all the air from ACD,AYC system. I dont know how to do it without MUT. AEM EMS will not comunicate with the MUT.

Good question, ill ask my friend, Mitsu Dealer.

 

turn the key on, and hold the gas pedal all the way down(5-10sec). It will prime the acd. Bleed it. Turn key off, repeat.

 

thanks for all the help. i will try it tomorrow.

 

Are these lights only on every once in a while when you first start up the car? And if so, do they just all three blink?

 

I did read the manual once, if all three are blinking, I believe you have a real problem. All 3 on, means get it checked out.

 

I have had all three on at once.. blinking.. and all it was .. was my tactrix cable was plugged in.. took it out.. problem solved..

 

all 3 lights stays on. once i start the car only one light is on. once i start driving than all three lights turns on. when i take the key out and the turbo timer is counting down onlyl one light is on. mitsu laptop wont communicate with the aem ems. thanks...