We are proud to announce the release of a new Torque Solution EVO 5-9 Engine and Transmission motor mount inserts.. Any questions PM us.. Information is below direct from the torque solution website..

54.95 shipped ( per side )




Torque Solution polyurethane engine mount inserts that replace the inner rubber material of the OEM EVO 8/9 engine mounts. Made from 75a durometer polyurethane. Each mount includes 2 half's and a center steel sleeve. These give you improved traction and reduced wheel hop without to much vibration. Bushings come with a lifetime warranty through Torque Solution. Fits Drivers side housing and Transmission Side..


•Eliminates wheel hop / traction loss
•Improved 60fts / e.t's
•600HP+ and 9sec e.t. torture tested
•75A durometer bushings
•Life Time Warranty
•Made in USA

 

www.awdmotorsports.com

 

Ttt......

 

All pm's answered. Bump to the top.

 

Bump.

 

Up.

 

Let me know what you guys need. I'll smash any deals you get from anyone else.

 

Is there a "how to install" on these inserts, I see the center whole is eccentric while OEM and billet mounts are centered, how does this work?

 

There is not a how to im sorry.. Ill see if i can install a set of these here this week and take some pics..

 

Long overdue bump.

 

bump.

 

All pm's replied, have a good weekend.

 

I hope you guys get to install one of these mount inserts soon, I´m thinking the alignment should be as shown in the attached picture. I did notice that the OEM support (also seen in the picture) does also have the center hole a bit eccentric as well. Oh, I did buy my mount inserts from your Ebay store!

 

That is correct, it brings the engine onto a more "level" position. The offset will face downwards as your picture shows.

 

Saturday bump.