How to launch GSR
Nov 5, 2008, 05:24 PM
#16
Evolved Member
iTrader: (21)
Join Date: Jan 2004
Location: South Carolina
Posts: 2,210
Likes: 0
Received 0 Likes
on
0 Posts
Perth: Because I know everyone is wondering.
http://en.wikipedia.org/wiki/Boorloo
http://en.wikipedia.org/wiki/Boorloo
Nov 5, 2008, 07:50 PM
#17
Evolving Member
Thread Starter
iTrader: (1)
Join Date: Sep 2008
Location: Australia - Perth
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
I saved about $5,000 AUD on getting a demo model with 2200km on so i can bet you anything it has been launched fair bit before me, clutch doesn't seem to slip yet but im looking at getting ACT further down the track.
Yeah Perth is boring. Sydney is better
ps. Sorry about my english before, just bad habbit from online gaming.
Yeah Perth is boring. Sydney is better
ps. Sorry about my english before, just bad habbit from online gaming.
May 12, 2009, 10:38 AM
#18
Launching is simple.
Step 1: Stop
Step 2: Push in the clutch
Step 3: Put the car in first gear
Step 4: Let the clutch out to find where it engages and hold it just before that (it'll make it easier to slip/dump)
Step 5: Floor the gas, and hold it to the floor. You will start bouncing off the 2-step at 5000rpm and build around 10psi.
Step 6: DO NOT let off the gas pedal at ALL, slip out the clutch until you feel it grab, then let go.
Step 7: DO NOT let off of the gas pedal until you shift to 2nd gear. The gas pedal should be held to the floor from the beginning until you shift to 2nd.
Step 8: Continue shifting gears accordingly.
that's how i've always done it, and it was good enough to get me and my basically stock IX MR to 12.82 @ 107.41 with only a cat back, no tune, no other power adders, a boost leak, and a possibly slipping stock clutch.
Step 1: Stop
Step 2: Push in the clutch
Step 3: Put the car in first gear
Step 4: Let the clutch out to find where it engages and hold it just before that (it'll make it easier to slip/dump)
Step 5: Floor the gas, and hold it to the floor. You will start bouncing off the 2-step at 5000rpm and build around 10psi.
Step 6: DO NOT let off the gas pedal at ALL, slip out the clutch until you feel it grab, then let go.
Step 7: DO NOT let off of the gas pedal until you shift to 2nd gear. The gas pedal should be held to the floor from the beginning until you shift to 2nd.
Step 8: Continue shifting gears accordingly.
that's how i've always done it, and it was good enough to get me and my basically stock IX MR to 12.82 @ 107.41 with only a cat back, no tune, no other power adders, a boost leak, and a possibly slipping stock clutch.
Thread
Thread Starter
Forum
Replies
Last Post
moey124
Evo Engine / Turbo / Drivetrain
3
Aug 16, 2015 06:25 AM