So the computer I use for tuning bit the dust the other day, and I need to go out and get a good tune into my car.

My question is this: I had the original version of ECUFlash and an oooold version of Evoscan on that computer. When I install the new versions of both, will I still need to go through all the same steps I did with the old ones? I.E. edit the data.xml etc for 2 byte load, edit evoscan for reading the JDM map sensor, edit to remove the rear 02, etc?

That was a lot of work and I don't remember everything I had done. God I hate it when technology bites the dust! (And go figure that was the one thing I didn't get backed up was all my tuning stuff).

 

if you can get those configuration and definition files off your old machine and copy them over your new one then it'll save you some works.