I was helping my buddy with his WRX last night with some logging. He usually uses Romraider for logging and flashing. I hooked my laptop up and took a couple logs with Evoscan, but had a little trouble with the loadcalc. It shows the load at 100 the whole time. Does anyone know what the problems is?

 

From the top of my head I would guess that you didn't select the right vehicle type in EvoScan.

If it were an evo I would say it was accessing the wrong MUT location, but I don't think many of us know anything about logging WRX's over here...

 

Why not just stay with romraider, since its made for subaru's, like EVOscan is for mitsubishi's

 

Yeah, ROMRaider is a much better choice for logging Subarus, but I still use ECUFlash for flashing the ECU.

 

Romraider is BUGGY.

 

After searching forever to try to find a solution to this exact problem, I found an address that actually works for the load on my 05 WRX. I use 000D instead of the default 07. Hope that helps!

Now im trying to figure out how I can get MapTracer to work for me. I need to change the load from percentage to g/rev like my maps and figure out how to get my ROM to actually load. Getting EvoScan to work has been the biggest pain in the a$$. I dont get why a program you pain for doesnt work, while the free program Romraider works just fine.