Official / Injector Scaling and Latency Forum
#302
Evolving Member
iTrader: (4)
Join Date: Sep 2010
Location: new york
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
just had a quick question is it possible to add more options to the evo 9 v7 Rom ? The 8 Rom has So many more options i was just curious because my 9 rom doesn't have battery voltage latency hex it only has compensation. Thank you
#303
Evolved Member
iTrader: (12)
Anyone using ID2600 XDS yet? Got the car running, but won't stay idling (have to keep a little throttle to keep it running). Used the dead times off ID's website, but not sure if it's a fuel issue or something else. Replaced faulty (leaking fuel into cylinders when sitting) FID 2000cc injectors and was fully tuned with those (ran pretty decently), so starting fresh with these injectors. What have people have success with? On stock ECU.
Scaling on E85 1500
Latencies are as follows:
2.13
1.47
0.975
0.6599999999999999
0.48
0.345
0.3
Scaling on E85 1500
Latencies are as follows:
2.13
1.47
0.975
0.6599999999999999
0.48
0.345
0.3
#304
Evolving Member
Quick question
Can you rescale the stock voltage table values to more common amounts - e.g. from 14.4 volts to 14 volts?
I'm assuming so but wanted to check
I'm assuming so but wanted to check
#305
Evolving Member
650cc rated
15 min cruise
15 min idle
Any advice? lower latency by 1.7% (or as close to)?
As far as scaling next jump is 622 (2.1% change) so leave that alone?
Thread
Thread Starter
Forum
Replies
Last Post
churchja
ECU Flash
1
Nov 12, 2009 03:15 PM