Need help fast??evoscan not working?
#1
Need help fast??evoscan not working?
hi friends iam using evoscan v2.6 iam trying to log a mitsu evo8 with 1000cc injectors but everytime i connect it disconects itself,it had the baud rate set at 10800 i think i moved it to 15000 and it works but the data it reads doesnt seem real so can you guys help me urgent!
thanks
thanks
#2
Evolving Member
iTrader: (3)
Join Date: Mar 2010
Location: Plano TX
Posts: 253
Likes: 0
Received 0 Likes
on
0 Posts
I had this same problem when Centrafuse was causing conflicts. The way I had to fix it was:
1. Shut down all programs
2. Launch EvoScan
3. Click Start Datalog
a. Get the immediate disconnect
4. Change from MUTIII to CAN 2006+
5. Click Start Datalog
6. Wait about 2sec
7. Click Stop Datalog
8. Switch back to MUTIII
9. Click Start Datalog
Now, if your problem is like mine it'll start logging but crap will look jacked up. Go to the "logging" tab at the top and switch back to Imperial units (somhow every time I had EvoScan jack up on me it switched itself to Metric too).
10. Enjoy finally being able to log
1. Shut down all programs
2. Launch EvoScan
3. Click Start Datalog
a. Get the immediate disconnect
4. Change from MUTIII to CAN 2006+
5. Click Start Datalog
6. Wait about 2sec
7. Click Stop Datalog
8. Switch back to MUTIII
9. Click Start Datalog
Now, if your problem is like mine it'll start logging but crap will look jacked up. Go to the "logging" tab at the top and switch back to Imperial units (somhow every time I had EvoScan jack up on me it switched itself to Metric too).
10. Enjoy finally being able to log
Thread
Thread Starter
Forum
Replies
Last Post
detroit pistins
Southeast Region
12
Dec 15, 2008 06:59 PM
j3ffw19
Water / Methanol Injection / Nitrous Oxide
42
Jul 20, 2006 12:03 PM