Logging Boost With Defi Sensor
Thread Starter
Newbie
Joined: Mar 2010
Posts: 7
Likes: 0
From: Sydney
Logging Boost With Defi Sensor
Attempting to log with evoscan the boost using the defi sensor....
i read through this thread
https://www.evolutionm.net/forums/ec...-sensor-2.html
which was quite helpful but im still stuck
ive tapped into my signal wire for the sensor and plugged it to the ecu on an evo 7 (point 77) which is not used...
what do i alter on my MUT table and and evoscan to get the reading to show up
formula is shown in the other thread but im not understanding link between the ecu pin and the evoscan request....
where can i read about this
i read through this thread
https://www.evolutionm.net/forums/ec...-sensor-2.html
which was quite helpful but im still stuck
ive tapped into my signal wire for the sensor and plugged it to the ecu on an evo 7 (point 77) which is not used...
what do i alter on my MUT table and and evoscan to get the reading to show up
formula is shown in the other thread but im not understanding link between the ecu pin and the evoscan request....
where can i read about this
Thread
Thread Starter
Forum
Replies
Last Post
