Changing transmission type?
#1
Evolving Member
Thread Starter
Changing transmission type?
Hi,
I'm in the middle of putting a GSR transmissione in my 2011 Ralliart. I saw a couple of other posts here where people would run ETACS Decoder and flip some bit. I also read that you could flip bit 1 in OPTION SET #4 for free, instead. So I flashed it, but I'm still getting "TRANSMISSION OVERHEATED. SLOW DOWN". Anyone have any idea what's going? Is there a difference between the ETACS decoder method and the ECUflash method?
I also heard that other's had success just installing a GSR ROM on their swapped MR, but obviously I can't do that on the Ralliart.
I'm in the middle of putting a GSR transmissione in my 2011 Ralliart. I saw a couple of other posts here where people would run ETACS Decoder and flip some bit. I also read that you could flip bit 1 in OPTION SET #4 for free, instead. So I flashed it, but I'm still getting "TRANSMISSION OVERHEATED. SLOW DOWN". Anyone have any idea what's going? Is there a difference between the ETACS decoder method and the ECUflash method?
I also heard that other's had success just installing a GSR ROM on their swapped MR, but obviously I can't do that on the Ralliart.
#2
Evolving Member
Is there a difference between the ETACS decoder method and the ECUflash method?
Though I don't know precisely but if there is 'mission type' in ECU CODING and it can be modified by ETACS decoder, I think it needs to be modified by ETACS decoder.
Thread
Thread Starter
Forum
Replies
Last Post
kazshell
09+ Lancer Ralliart General
11
May 12, 2011 05:48 AM
captobvious75
09+ Lancer Ralliart General
139
Dec 16, 2010 08:08 AM