Hi Guys
I recently tried to log Aem X series WBand using Rear O2, its a Evo 7 manual ECU with pin 75 as rear O2.
White signal wire to Pin 75, brown wire to sensor ground.
The values logged are stuck at 20..
I tried different formulas but unable to get any response. Request ID 3c - 8409
Formulas used are below, i changed the formulas but the values are stuck.
0.046787*+7.31845 -> Values stuck
10.00+(16.99-10.00)*x/255 -> Values Stuck

Your valuable feedback is needed.

 

Bump !

 

Did you update to EvoScan 3.1? Hamish mentioned something about fixing the series x data with this new release.

 

Hi Robbie,
The first thing i did was checking for the updates, it does say checking for the updates but does nothing.
Is there anyway to install manual updates for Evoscan ?

 

Yea, you have to go to Evoscan.com, log into your account, go to downloads, then find the 3.1 version to download (it includes instructions for the update once downloaded).

 

I already have evoscan 2.9 downloaded . They are charging 25$ again for any of the downloads.
Can you send the 3.1 setup through email ? captain.stroker@gmail.com