evo8330

how can i activate the stationary rev limiter? i try the search function but dont find that i search...

my rom are the 96530006. on ecuflash is set to 5000rpm but dont work

thanks andy

SEEnoEVO

iTrader: (21)

Are you putting the car in gear, at a stop, clutch in, and holding down the gas?

newimportowner

iTrader: (2)

Do you have an 03 EVO 8 by chance?

evo8330

no its a 04 EDM gsr.
the stationary rev limiter dont work... i put the clutch and the acceleration pedal... is possible that is dissactivate?!

nonschlont

iTrader: (3)

On my usdm stock launch control is 5000. When you have the clutch in, then put it in 1st gear, and slowly hit the gas to reach the set rpm, (you can actually pass it, if you just WOT) it should hold the rpm's at the set rpm, once you can tell the 2 step in activated, then press the throttle 100% WOT, the feather the clutch, quickly, but dont dump it either.

And if thats doesnt do it, then somethings up..

Kracka

iTrader: (49)

Make sure your car is sitting perfectly still and not rolling at all.

Crazy K

iTrader: (8)

everyones right, make sure your at a complete stop and I like to blip the throttle up to around 5700rpm which is where mine is set, also pull your ecu rom and make sure your stationary rev is set to whatever you want, on my 03 usdm it was set at like 7600rpm from the factory

evo8330

my stationary rev limiter is set from factory to 5000rpm..
tomorow try again...

Skylineracer

iTrader: (21)

a mini thread jack but what is the procedure to enable the 2-step on a 04 evo 8 usdm

SLO-EVO

iTrader: (52)

make sure that youve enabled the feature, then just open it and set it to what you want to launch at.