I just got my logging cable and took my car out to do a run. I logged my data using Mitsulogger 2.0 and used virtual Dyno 1.0.8 to estimate my run. The weather inputted is correct.

Car is bone stock except for an AEM intake and cone filter installed by the previous owner. The filter is pretty dirty I will be replacing it as well as installing a new 4-bar MAP sensor and AFR sensor(LC-1?) before I do any tuning.

It makes sense to me but I just wanted to run it by others to make sure my numbers were close to expected. I guess I'd just like to know I'm using everything correctly before going further, I've been reading a lot about this the last month and I think I'm on the right track but would rather get caught now before I screw something up.

Thanks in advance

 

Use the "Dynojet" setting. The "dynojet" setting, will read as same a uncorrected dynojet.