Hello guys,

Tommorow i'm going to install my old GPS unit (Avic 9DVD + AVD W8000 display)

Before i begin i wanted to ask some information in here.The installation is not so hard for me, but finding the wires to connect the device is more difficult

So can you guys tell me where i can find or which color the following wires/connections have :

- Car Speed Signal (Speed-Pulse Signal)

- Reverse Gear Signal

- Driving Lights Signal

- 12V source (regardless of ignition switch position)

- 12V source (when the ignition switch is on ACC)

I also have a connector in my car, but i dont know if i can use that for any of those things i mentioned above.I think it's ment to connect a Radio-unit and not a GPS unit.
I the future i will also install a Head Unit (Pioneer DEH-P9800BT), so i think it's best to leave that connector un-touched.







Thanks

 

Do a search for "IX ecu pinout" you can find what you are looking for.

 

Ok thanks !

From what i can make of it it is Pin no. 80 Black/Yellow
Is that correct?

https://www.evolutionm.net/forums/at...7&d=1145414424

 

Radio 12v red/black + radio harness
Radio Ground (chassis)
Radio Ignition blue/yellow + radio harness
Radio Illumination green/white + radio harness
Factory Amp Turn-on N/A
Power Antenna yellow + radio harness
LF Speaker +/- red/white - red/blue +,- radio harness
Notes: If equipped, the amplifier is under the driver seat.
RF Speaker +/- red - green +,- radio harness
LR Speaker +/- white/blue - yellow/red +,- radio harness
RR Speaker +/- lt. green - yellow/green +,- radio harness
reverse light is brown in the drivers kick
and thier is no vehicle speed sense wire in the car

 

Hello

Thanks for the reply.

I've allready installed the unit though

But there is a speed pulse signal in the vehicle. It is the yellow/black wire on the ECU


Grtz