All im showing here is his work (wich is bad ***) im not going to get in anything else, just as long as MY name is clear here im kool

 

I've been meaning to stop by your shop because we are in Tulsa all the time. I always seem to run out of time. Maybe I can get by there this month as I will be at Hallett for the NASA TT on June 17-18.

jeff

 

A local DSMer got a head from BJs, and it had some issues. The porting was fantastic, but the valve seats on cylinder one were not even close to round. 0 psi compression, naturally. Had a local machinist (that does all my work) fix it. Even he commented on how good the porting was That head in the original post sure looks good, but I would just recomend inspecting the head closely before installing it in case this one has similar issues (different guy/shop cutting the seats?). Could save you a little time/trouble. Good luck!

As a side note, the BJs sheet metal intake for the DSMs was my favorite, beautiful piece of work.

 

Yea the car is currently running this headand his sheet metal intake