Saw this cast manifold on ebay and was curious: ebay link - cllicky clicky

Is anyone using this in a setup or have opinions? Personally, I think fabbing up a kit takes work and with this manifold and say a precision turbo, some work such as downpipe, 02 housing oil lines, etc would be necessary.

Thanks!

 

That would actually work well for like a 50 trim setup....It would'nt be hard to fab up a dp, and the oil feed and return would be pretty easy...Then you can just block off the coolant lines. You could do a nice setup with that for a decent price if you know what your doing.

Plus thats actually an inexpensive manifold compared to others on the market and the only one that is cast for a t3 turbo instead of the tube manifolds which will all crack in due time...

 

I have heard of revhard cast manifold exhaust chambers being very small. Some serious extrude-honing or porting would really help in that case!

I agree that if someone knew what they were doing, they could run PTE turbos which are quite cheap.

Surprised no one has gone this route and mass produced a kit already.