jackson auto machine?
JAM are some of the most down to earth folks you'll talk to. AFAIK, they used to build Sean Glazar's motors, or at least do the machine work. Call Carmela and talk to her. I spent many HOURS talking to her on the phone and in person. She'll hook you up. She did the valve job and Jerry did the rest of the motor including the head porting and rotating assembly in soundfx007's car. Jerry know's his ****. How many other shops on this board have an ENGINE dynamometer in the room next door to the clean room where they assemble their motors?
Originally Posted by CO_VR4
That's unusual. Most automobile machine shops will assemble a long block for you, particularly if they do both the short block and the head. Many prefer to do that, just to make sure that it's done right and the stack up tolerances fall within limits.
I sure don't understand why they would install your balance shafts if you had them machine and assemble the short block. That's just strange.
I sure don't understand why they would install your balance shafts if you had them machine and assemble the short block. That's just strange.
Note: JAM, if they receive a complete longblock they will send you back a complete longblock w/ all their goodies inside.
Thread
Thread Starter
Forum
Replies
Last Post
AboodsEvo
EvoM New Member / FAQs / EvoM Rules
8
Nov 22, 2010 07:34 PM
