I am planning on picking up a 2006 EVO MR. What can I expect my 1/4 mile times to be like if I go with Buschur's stage 1 upgrades for the IX?

 

I am guessing from your thread looks like low 12's for IX. Assuming your superior driving skills right

 

i've run a 12.4 @ 112 on 93-pump with just stage1

there's much better times out there though

 

Stage 1 with an EVO9 that has been properly tuned, at 22-23 psi on 93-94 octane and an offroad pipe can put the car into the 11's actually. The EVO9 is amazing with Stage 1 on it. Our BR350 cars through the stock cats are putting down 295+ on our dyno. We've had quite a few customers run 11.90's at 280-290 whp on our dyno.

You won't be disapointed.

 

That also depends on location factors altitude, heat and humidity.

 

Great...if all goes well, I pick up the EVO tomorrow at the dealership. I will be out to visit your shop in the next few months to at least go with stage 1 upgrades.

You might remember me...I had a silver EVO that had the Vishnu chip and you installed cams and a fuel pump for me.

 

I personally just installed a BR stage 1 minus the reflash and i must say it's a night and day difference. I could only imagine how much smoother it can be with some tuning. Buschur products are no joke, pure performance parts that do what they are supposed to be doing...Making your car faster, not to add bling factor.

 

is there a link to this stage one kit?

 

^^^https://secure.buschurracing.com/cat...bb977713be0157

 

do these stages apply to both 8's and 9's?

 

And best bang for buck.That why i reccomend Buschur!!

 

Picked up the EVO from Roby Mitsubishi near Columbus, OH. Car is great

Now lets see how long I can hold off before my first mod

 

Nice! what color did you get? and I was thinking mid-low 12's with a BR stg. 1 but then again I suck at launching!

 

Yes, Stage 1 is the same for the EVO8 and EVO9. Stage 2 changes slightly as we don't recommend upgrading the BOV on the EVO9, the stock one is very good.

Thank you.