bull crap

 

bump

























<<>><<>><<>><<>>

 

bull crap

 

Definitely sounds like a installation issue. It shouldn't be making those sounds in neutral, regardless if the slave/master cylinder is leaking. Take off the tranny and have a look.

 

bull crap

 

Two of the bolts SNAPPED off?! Why are you even asking us if there is something wrong when you already know exactly what is wrong? If any bolts are missing from the pressure plate, the throw out bearing will not evenly engage the fingers, and it will emit a really nasty noise.

 

bull crap

 

OH! Sorry for the accusations then! =) Good luck with the re-installation. If they snapped off, it means they were over torqued.

 

bull crap

 

wow, i am really sorry to hear that eric. i hope you can get this fixed quickly.

what shop was it if you don't mind me asking?

i understand if you don't want to post it here. people can get awefully butt-hurt about "bad mouthing" shops.

 

i blame the 3/8 impact gun

 

Impact gun on a pressure plate disc, that would be hilarious (probably what happened too hehe)

 

hahaha impact gun on pressure plate bolts
sounds like a GREAT shop

 

The bolt head that snapped off most likely would do no damage. Most of time if anything breaks inside the bell housing, gravity does it's job and pulls it to the floor of the bell housing out of the way of the spinning flywheel/clutch assembly. You should fine