Congrats man, hope you like them. 8 hrs? Granted I haven't swapped cams in my evo, but I can swap cams in the Talon in less than 1 hour.

 

Love the power cams make... Nice install... Too scared to do it myself.

 

would 20 minutes by highway be too far? I just ordered a 10.5 hotside 02 housing and some comp 280 cams and am considering doing the installs myself to save about $600. But i would need to drive a ways to get it dyno tuned.

 

Just don't got WOT with the car, even under slight part-throttle boost your car should be fine.

 

What size wrench did you have to get, I plan on doing this myself soon.

 

im ordering mine next week, i wanna install them myself but im scared

 

very interesting install it was today

 

those 4 or 5 pics u posted made it look like u just popped off the valve cover and swapped em out...lol. i plan on doing this to my IX as well. Did you bleed the lifters? I would like to get some details from you before i jump on this myself. Im in iraq right now but ill be home in less than a month.

 

nice job man...i also would like some more info cuz im putting in a set of GSC S1's in about a week and have never done this either!

 

Just finish my install of BC 272 today, me and wife did it. Its not hard, it just takes some time. Make sure that the timing is right after install. I ran into that problem.

 

nice lil write up!

 

very nice.

 

I had the Cosworth 272 cams installed in my IX. I only felt a increased mid-range power nothin in the lower or the top. I used supertech dual valve springs and retainers. Along with ARP head studs. Idle is slightly rough, but kinda cool. Check out my write-up. I definately expected more power.

 

Great job with the pictures. I swear whenever I start working on the Evo, I promise myself that this time I'll take pictures and do a writeup. Sadly, after the second picture, I get too lazy.

 

once tunned you will notice that the car wont fall on its face after 6500 rpms if you havent already

good lck do good stuff