Took forever for me to get the time to finish this up. Here it is. I just need to weld on an 02 bung and its ready to go in.





Sorry for the bad pics but my phone is the only camera I have. I think it came out nice. Can't wait to see the results.

 

Hmmm.....

 

that O2 housing looks pretty small......

 

Good job on the fab. When will you have this on? I bet it will work nice.

Fathouse

 

That turned out nice!

 

Me likey..interested since i run higher boost.

 

Looks good! Nice meeting you the other day!

 

Very interested in your results! Keep us posted when you install! And for gosh sakes don't forget the pictures!

 

Do you think you would want to duplicate this? I can send you a turbine housing to work on if you dont have a core. If you are interested PM me for cell #.

 

^^^ Also interested, shoot me a PM regarding pricing!

 

This is a machined 10.5 hotside where the flapped area is completely taken out.

This was not cheap. I am the type of guy where I like my car to be a little unique than others so this was worth every penny to me.

It was nice to meet you too. I am sure we will all meet up again before I go back to school.

 

why didn't you just weld the flapper shut and run a manifold with dual wastegates at the collector? cost prohibitive?

 

This is the only proper way I see doing it for our cars. I have seen a megan manifold on ebay with two runner routed to a wastegate flange but those manifolds are garbage and unreliable. I have only seen one stock manifold with a tial 44mm welded to a single runner but that isn't the right way to do it. This worked out better and will look a lot nicer installed.

 

Looks really good! I hope you can give us some results soon. Looks like it'll be pretty affective.

 

That thing looks badass! Be sure to keep us posted with the results when you install it. Looks like it took a lot of time and effort and I am sure it will pay off when you finally install it. Mad props man for being original and building it yourself!