FYI you can pull the engine and transmission at one time. i know cause i just did it. all you need is an engine load leveler.


good luck with your build

 

I don't even know what an engine load leveler is, but for my purposes I needed to take the trans off in the garage anyway.


Cool info though, thanks.

 

+1 we pulled mine all in one. Didnt use a leveler. Just brought the bish on out.

Even put it in with the trans attached.

 

Now that I might do........put it back in with the trans attached to it.

 

http://www.cvfsupplycompany.com/enginesling.html

 

thanks for the information man

 

Ben, you suckkk. Is it done yet?.lol

 

Have about 3 ppl there to help you, its a close fit but it works. Saved us a bunch of time. Have it at a big angle with the trans pointing straight down.

 

Hahah yeah right it wont be done for MONTHS.

 

i just figured if you were going thru all that work, you might as well build it up. i would do a built xfercase + trans just for peace of mind. i have a 12sec car & split my t-case on Pass Time!!! my built trans & Tilton Twin held up tho...

 

Probably let the car wheel hop am I right?

 

best of luck buddy

 

No offense but with those mods it should hold up.


Ive made 70+ 500whp passes on stock trans/tcase.

 

I've probably made that on my TC....I blew the trans 2 years ago letting the car wheel hop out of the hole.


Evocrazy I see we are going with the same cams heh, what cams were in the car when you had it tuned?

 

i just figured if u pull it out, why not build it up? don't 1/2azz like alot of ppl when they build their cars up. do it right the 1st time & u won't have issues later.

what they didn't show everyone on Pass Time is they had me do a burnout b4 lining up to run. since i already use Advan A032R's, they stuck on the launch, everything else turned splitting case in 2 places + blowing pass side axle seal...