Looking for a t3 manifold to put my own kit together. I'm going to fab my own piping. I know rev hard makes a cast unit, but haven't been able to find much else. Not interested in spending 1100$-1200 for a tubular. Any other ideas?

 

Hafe

 

DNP, ETS its about 900 or you can look for one on the forsale section on here ive seen a few on here for the past few months.

 

I hear alot of horror stories about the hafe cast manifold. Everything from surging to o2 housing bolts that keep backing out. Maybe some hafe manifold users can chime in.

 

Ebay sells a full race copy all you have to do is port match and clean up the weld sag in the merge collector. Its about $200 comes with dp but i dont trust it.

 

hmmm, ive never used hafe personally but ive never herd the stories youve said.

sbr uses the hafe mani in their turbokits.

idk

 

yeah, i wouldnt buy the ebay copy unless i knew how to weld really well (i.e. be able to fix it when it breaks). in which case i would just make my own manifold

 

I did a search and found quite a few people with the problems I mentioned. Any hafe manifold users wanna chime in on this? Also anyone use those dnp manifolds, they are cheap but only offer 1 yr warranty

 

I ordered 5 manifolds for me and a few budys they used theres i didnt all the other cars have held up after they port matched and cleaned up the weld sag. They all have 35R's on the cars power on pump gas is over 400+. It works welds hold up just fine. Send it out for a nice coating and your set. I sold mine i went with a T4 topmount.

 

I have a SBR GT35R which uses the HAFE manifold and o2 housing, and haven't had a problem so far.

 

Our Super Value manifolds are both tubular AND reasonably priced at $699 separate of the turbo kit. If you have any questions don't hesitate to get a hold of me!





Tom

 

Here is one of the most recent ones we made for a local customer.. Not 1100.00 either.. We also have the ETS Equal Length in stock and HAFE w/ 2000 Degree coating..

 

sounds real good for that price...a couple questions though tom!!!

--i would like the price for the manifold and 4 bolt downpipe....
--what provisons are needed to actually bolt on the stock heat sheild?

thanks

 

Purdy.... how much do you charge for a manifold like that?

 

Pm for pricing.. We have a few options.. Thanks!!