oreoevo

iTrader: (2)

I did the swap...works great! I still need a 6 speed center console...lmk if anyone has 1

lttldggr

I just contacted shep for a 5 to 6-speed conversion... waiting to hear... we'll see what I decide to do... whatever I do decide.. this is turning out to be an expensive endeavor... with my 2.3l conversion also... and whatever else I can figure out to do while my engine is pulled.... my wife is going to kill me!

jnebs

iTrader: (9)

my 6 speed is strong and im around 400whp

Evilution23

iTrader: (7)

i just heard bad stories about the 6 speed especially for "spirited driving" Mitsubishi in essence put an extra gear into basically the same 5 speed casing. with the extra gear causes more moving parts which equals more heat. from some people i heard driving hard too long you overheat the transmission and start breaking. i mean i dont drive "spirited" all the time but i like the 5 speed for more insurance just because its strong. just my 2 cents however

Roadrunr

iTrader: (24)

The parts to go from 5 speed to 6 are over $600. including the 6 speed console. I have all the parts to do the swap, brand new.

https://www.evolutionm.net/forums/sa...arts-sale.html

Don

4doorstreetbike

let me know if someone wants to trade their 5spd for my 6spd..

oreoevo

iTrader: (2)

Dont do,it,bro!!! I did it just so I could drive it while 5speed was getting built... Garbage

oreoevo

iTrader: (2)

Def not worth the headache of changing cables shifter, mounts

oreoevo

iTrader: (2)

I have a fresh never used shep 5 speed with ultimate ratio for sale comes with cables, mount shifter and everything needed to install in a 6 speed.car

Butt Dyno

iTrader: (10)

I've been digging around for this and haven't found it. Anyone got a link?

AcceleratedAuto

I just bought a 6-speed and will hopefully have TRE rebuild it as I live close to them. The tranny came with the shifter cables, tranny mount and shifter mount. I'm probably going to get moderately crafty and dremel out my 5-speed center console so that the 6-speed shifter and boot will work. Unless I can find a 6 speed console for dirt cheap.

Butt Dyno

iTrader: (10)

Want to trade? I'm going 6 speed to 5 speed soon

sirednk3345

Hi all I have a 2010 lancer evolution GSR and I’m having issues trying to bleed my clutch. Can anybody help me out as what should I do? I’ve tried bleeding and still do not have a good pressure on my clutch pedal.

AcceleratedAuto

I would be interested IF, I had an Evo 5-speed that I was pulling out. I'm doing some wacky stuff and pulling the 5-speed f5m42 out of my Ralliart and putting in an Evo 6-speed.

AcceleratedAuto

Here is a decent guide from TeamRIP. I've never done it myself and don't have any tips for you. I'm sure there are plenty of YT videos too.

http://www.teamrip.com/clutch-bleeding/