I have a leak at the speed sensor on top of the transmission. I recently had work done on the car and I am wondering if the seal is messed up on it. I guess it could also be cracked.

I was wondering if someone could tell me if removing it is as simple as removing the bolt. I don't have the service manual on me since I am 4 hours from home. I tried tightening it up a little but I didn't see any improvement.

Any suggestions on the removal?

Thanks...

 

Started this thread in distress trying to get the car ready to drive back home.

After thinking about it, I pulled the vehicle speed sensor (simple as a bolt) and the o-ring was separated into two pieces. I put a new one on and so far no leaks...

At least I could get to it without having to remove anything...

 

Yeah. It's just a single bolt.