So I'm looking to see if anyone knows the flow rating on the Black? The Red is 60 lbs/min but I'm not to sure that I have seen the "specs" on the Black yet. Also does anyone know the inducer and exducer size for the compressor wheel and turbine wheel on the Black...

Mikey

 

this was posted by ninekrevs in another thread...not sure how accurate these dimensions are:

FP Black
81mm HTA compressor wheel ??(1mm smaller than their 35r)
70lb/min??
67mm turbine wheel – 60/67

compared to

FP Red
76mm HTA compressor wheel - 56/76
57lb/min
67mm turbine wheel – 60/67

 

Repost!!!!

 

Thanks Aby. It sounds about right, however I really wanted to know the specs on the Black compressor wheel.

 

If it's a repost then tell me what the spec on the Black compressor wheel is. I can't find it.

 

70 lbs min is accurate information Aby.

 

Buschur has the Black on their site and say its a 68 lb/mn compressor

 

Prior to us testing the prototype, I was told that the turbo would flow close to, if not more than, 70lbs of air. Thiis proves to be very close to what we observed and logged. 566whp/60lbs=9.43 whp/lb of air on the Red(Buschur's Mustang) vs. 686/70lbs=9.8 whp/lb of air on the Black(Cobb's Mustang). The only difference being 4% lower numbers on Buschurs Mustang vs the Cobb Mustang.

 

I just received a message from fp telling me that my FP-BLK is ready to ship!!

i'm not sure if i have the funds for it right now....

I'm not sure if i should buy it now or pass it on....anyone interested?

 

did they tell you a price? tell them to pass so I can move up on the list.

 

Aby get it bro

 

Mine gets here on Thursday Aby and my car will be down at James shop soon after so if you're interested you can come see the results after a tune on E85 at ~30lbs.

 

I've heard the FP people reference 68lbs a minute as the 'number'.

 

That is correct, that is advertised! On a well setup car and a great port job on the Black it can flow 69-70lbs a minute. Should be interesting as more and more start to flood Evom with dyno graphs

Mikey

 

Thats what Robert told me when I spoke to him as well. Mine should be shipping out soon

I will have back to back numbers as well, albeit a very low reading Mustang dyno.