Hey I bought a QM clutch for a 6spd tranny but I never installed it. I am going to do a 5 spd swap but I still want to use the clutch. My question is what would I have to change to make it work with the 5spd? I forgot who it was but one vendor told me all I needed to due was buy the 5spd rebuild kit for it but I soon found out there was no whole "kit", you buy what you need (friction discs, floaters etc.) I know its not the spline because I slid the 6spd discs onto the input shat on my 5spd and they fit fine.

 

you need the 5 speed clutch slave cylinder (hydraulic bearing i think QM calls it).

 

Clutches are the same.. Just the TOB is different. Did you recive the TOB with 4 bolts?? any pictures. I can tell you if you post a picture of it.

 

I gotta check ill get a pic posted. Thanks for the info though its much appreciated.

 

Ok took some pics my clutch box had two boxes labeled hydraulic release bearings. Theres a 3 bolt one and a 4 bolt one. Oh and the 4 bolt one on the box is labeled for a Evo VII (p/n 710045). (I know about the slight surface rust )

 

4 bolt one is for 5 speed.

 

Ok cool, was I supposed to get two? Or is the other something different? Thanks

 

Hey does anyone know if I was supposed to get two?

 

uhhh, not that I know of, Where did you get the clutch? Anytime I have ordered a QM twin for an evo they only send one TOB. Sounds to me they sent you both 6 speed and 5 speed on accident, or unless you paid extra.

 

Got it for a good deal brand new from a guy on here said it was for the 6 speed. But yeah unless he paid for two or they accidentally sent two like you said. Anyways thanks for the help , hopefully this thread can help someone in the future if their in a similar situation.