so driving my car and when clutch engaged or standing tstill the car is hittin 2200 rpms and afr is reading --- :X !!!!


turned the car off then on again and everything was fine why the hell was my car forced at 2200rpm with clutch engaged and driving under2200 rpms it wud drive itself ina way

then turn the car on and off its fine ??

 

wud anybody know why my car wud be hanging at 2,000 rpms ?! then when i turn it off and on it goes away ?

 

Clutch in you mean?? That is disengaging the clutch.

Was the car warm?

 

maybe throttle cable got stuck? .......when it was hanging did you try to give it gas?

 

ISC motor maybe. Or even your coolant temp sensor to the ECU is not reading correctly and is telling the ECU your engine is still in warm up. Use Evocan and check it out.

Good Luck

 

with clutch engaged and disengaged it happens

when i give it gas it goes loll

just dont wannt fudge nething up

 

Wow...you should probably not drive the car then ...

Also, the word is "nothing", not "nething"....

 

but when i turned the car off and then on again it was fine ??

 

^^^ Hook it up to a laptop, use Evoscan.....you will find your awnser

 

where can i get evo scan ?

 

I found this to be hilarious. Good luck OP.

 

when the car is STANDING STILL wether clutch is engaged OR not the rpms hand at 2200

when i release the clutch ina gear it drives itself in a sense up to 2200rpm then when i control it on the gas pedal it drives normally

now when i turned the car OFF then back ON again the car was fine

the car was warmed up

just had my waterpump changed with my 60k kit


anyone have ne advice ??

 

yea everythings funny when it isnt happening to you ... if u dont got nethin to say positvely to the subject then shut it homie

 

what does ISC motor maybe mean ??

 

Idle speed control motor. Attached to throttle body with three screws. If it's bad Mitsu charges over $300. Get it from Amazon instead at $160