Hi Gents,

Before I pull my motor out of the engine bay, can someone please tell me where the lifting points are...?
Will be using a chain, however, can organize slings if need be...
I notice there are a few threaded tapings in-front of the motor, just below the exhaust manifold location...

Any advice would be greatly appreciated!

Thanks.

Phoenix*

 

i used the bracket in rear of motor next to thermostat....just took one of the bolts out and screwed it in tight.

i think on the front i used one of the exhaust manifold bolts..... as long as its screwed in all teh way i didn't think it mattered

 

there are two spots on the head, one on the front of the head and one in the rear. ill put a pic up to show you when i put my motor back in. hope it helps!

 

Thanks for your replies...
See attached image...
What are these available threaded tapings for...?

 

a few of the lower ones are for some stock brackets that mistu puts on the car from factory. mostly for exhaust support IIRC