need advice plz

ATM I have 3.5" Perrin with in/outlet 2.5", and I am going to install 3" TB so I would like to make piping 3" and IC with outlet 3", I came across on

http://www.maperformance.com/treadst...hick-3138.html

what do you think? or may be there is smth better? or its is better to stay with perrin?

 

Link no workie...

 

http://www.maperformance.com/treadst...hick-3138.html

 

The issues you will run into is that looking at that IC the inlet/outlet of the IC come straight out so you may see once mocked up that some bumper modification may be needed

 

I do realise it, but I am wondering is it as good as Perrin?

I am going to install a 3" TB and I would like to make piping 3".

I undertand about lag with bigger piping, but in case I will lower the incoming air temp I will be able to make more agressive angles - result is more POWER, and thats what I need

 

I have just checked sizing

perrin - 25" x 11.75" x 3.5"
tread - 22" X 12,5" X 3.5/4.5 I am looking to get 4.5"

 

Like I recommended in my PM to you, I would recommend sticking with what you have before jumping up to a 3" UICP, as it is overkill for your turbo/setup.

 

agree unless you have a setup to support and Need 3inch IC pipes you will gain nothing by doing so. its been tested time n time again.. actually i think david buschur did the tests years!!!! ago. 2.5inch IC pipes and maybe a 4inch high flow core n you should be good for 800whp

 

ok, will get 6466 or 6766 first )))

thanks

 

6466!!!

 

The Perrin intercooler core is actually 3.625" and is a very effective and proven unit; keep it.

 

The perrin is good only one I liked more is the buschur race. I would keep it as well.

 

buschur is good, and perrin

 

thanks for your help! first turbo, second buschur IC

 

I would go with turbo, then when it comes time to make some power, do an ETS intercooler.