To Those Who Have a MAP Performance Engine
Its their new stock framed turbo coming out soon. There is a couple guys that are testing them now in the dyno forum. Similar to a 6766, output is around 800-900 with faster spool than a PTE. Check it out so far: TPG Evo FP Zero 9.51@151mph on 33psi! - YouTube Killin it
As for 2.4L gaskets, a stock 87mm hg will work fine, assuming your machinist does his job.
OP - MAP makes a great motor. Their porting is excellent and is proven better than most. Plus their pricing is quite reasonable.
As for 2.4L gaskets, a stock 87mm hg will work fine, assuming your machinist does his job.
OP - MAP makes a great motor. Their porting is excellent and is proven better than most. Plus their pricing is quite reasonable.
If I didnt build my own engines, I would buy from MAP. Great service goes a long way. I just talked to my buddy that has his build from MAP and he has 15K on it so far. Not 1 problem in 2 years.
Had a map motor for the 6 bolt dsm I dropped in my truck. Turn around was no that bad. It had a little hiccup but currently runs strong. Would buy one for my evo 8 if the time comes. Just would have been better for me if they gave complete long blocks ready to bolt in at the time of the hiccup.
Thread
Thread Starter
Forum
Replies
Last Post
Blackevo mr
Evo X General
1
Oct 21, 2015 03:20 PM