so i just finished my double pumper which wasnt all too bad, but i cant figure out how to route the fuel lines coming off the pump assembly. Im running 2 -6AN lines and i cant get them past the tank without them getting pinched. Ive tried partially dropping the tank but that doesnt help at all. i am beyond frustrated at this point... does anyone have any advice for routing the lines?

 

Mine run just in front of where the factory bracket for the return line is on the front driver side corner of the tank. I had to drop the side of the tank to run them, but with the tank back in place there is space to move them.

 

Try lubing them up before feeding them through.

 

I ran my out through the passenger side, tons of room.