Evo IX MR - Clutch problem
#1
Newbie
Thread Starter
Join Date: Sep 2017
Location: Gothenburg
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Evo IX MR - Clutch problem
Hey everyone. Been on this site for a while (not as member) and been getting lots of information but couldn't find a thread with my problem.
So, I'm currently running a stage 1 tune (380 hp in engine, not whp). Using a ACT 6-puck sinter clutch with lighter flywheel.
I launched the car (which i now regret) and it went away as normal, but when i pressed the clutch it felt a bit soft so I immedietly stopped.
Now when im standing still and engage the clutch in 1st and try to drive, the clutch makes a sound like something is sliding against something inside.
I can drive the car as "normal" and clutch aint slipping. Makes a bit of the same sound when I shift down in gears (not if i increase the rpm before shifting). I drove home when this happened and parked the car.
Is the clutch wrecked or might it be something else that i destroyed?
Sorry for long text
So, I'm currently running a stage 1 tune (380 hp in engine, not whp). Using a ACT 6-puck sinter clutch with lighter flywheel.
I launched the car (which i now regret) and it went away as normal, but when i pressed the clutch it felt a bit soft so I immedietly stopped.
Now when im standing still and engage the clutch in 1st and try to drive, the clutch makes a sound like something is sliding against something inside.
I can drive the car as "normal" and clutch aint slipping. Makes a bit of the same sound when I shift down in gears (not if i increase the rpm before shifting). I drove home when this happened and parked the car.
Is the clutch wrecked or might it be something else that i destroyed?
Sorry for long text
#2
Evolving Member
iTrader: (2)
Throw out bearing may have come unclipped slightly. I've had it happen.
Take out the sight cover in the bottom of the trans, un clip the TOB, and try to reattach completely.
They can also break and not allow a full connection.
It could also be something entirely different.
Take out the sight cover in the bottom of the trans, un clip the TOB, and try to reattach completely.
They can also break and not allow a full connection.
It could also be something entirely different.
Thread
Thread Starter
Forum
Replies
Last Post
diamondblackix
Evo Engine / Turbo / Drivetrain
15
Sep 1, 2016 05:18 AM
Vivid Racing
West Region
0
Feb 25, 2010 04:35 PM
Go_Lancer_Go
Lancer Tranny/Drivetrain Tech
17
Jul 23, 2005 07:09 PM