ok i took the trunk badging off but now i have this glue here. and im not sure how to get it off. read the how to on this and it said to just use some elbow greese .... seems my elbow greese sucks =/ anything i can put on the glue to take it off without harming the paint. thanks

BTW i tried the hairdryer. =/

 

That Goo Gone works well. Those orange based solvants work -- just look for a product that says will not harm paint on cars.

 

Goo gone and wd-40 seem to be the most common.

Follow it up with a good wash & wax.

 

i was ready to use goo-gone, but didn't need to, the stuff came right off, like cake.

 

Goo gone, a hair dryer, alot of work and a few hours later it came off for me.

 

looks like i need some goo gone..... Stuff is not coming off easy at all

you guys have any problems with seeing the lettering in the paint (like a shadow) after you take off the emblems ? was kinda worried about that.

 

I had a slight problem, but after claybar and wax I had no issue with it.

 

goo gone


mitsu did make something strong

 

Slightly off topic, but what is clay bar, how do I use it, and where do I get it? I sometimes use Megauirs Scratch-X, is it like that?

 

^ http://www.properautocare.com/usclaybartor.html

it's similar to modelling clay in a way

 

U can use ur thumbs till they hurt.... then u use some Burn Treatment for ur fingers ive seen it work..

http://www.chclibrary.org/micromed/00041040.html

 

second that! wait till its hotter out!
i used my wifes blow dryer to heat it up and it came off fckin fast with the big finger method!

 

hahaha i made of thread on this on the show & part. many replies:goo-gone, wd-40, blow-dryer, 3m adhesive remover, brake cleaner, fishlines, dental floss, even peanut butter...but the one that came up most was goo-gone. mine came off by putting on wd-40, blow dry it a little and wipe with cotton towel. it took like an hour, good luck!

 

Brake cleaner? haha that $Hiat is really strong, i remember trying to clean a throttle body with some of that stuff and some got into my eye i think its stronger than pepper spray lol.. Whatch out for that paint..

 

hey the best way to get off the foam tape is to , use the rubber side of a (tire Valve stem).

Place the threaded end into a drill and use low speed to remove the tape.


Plus the rubber will not scrach the paint either.