I saw a picture somewhere awhile back of a custom made gauge panel that replaced the cubby under the A/C controls in the lower DIN location. It was made of the same matching fiberglass as the panel that surrounds the upper DIN and A/C controls. It was actually similar in appearance to the Craig Hardy panel except that it mounted below and held only two gauges. It also did not replace the factory panel. The gauge mounts were slightly angled up and the toward to the driver.

Anyone seen these anywhere?

 

Are you talking about the radio relocation kit?.. I have that but I don't think its the same fiberglass your talking about.. I have my SAFC sitting down below

 

No it is not the relocation kit. It is actually a fiberglass pod that holds two guages that sits in the same location where your radio would be if you had the relocation kit.

 

https://www.evolutionm.net/forums/sh...=153399&page=3

That was what you were looking for. I don't think it is in production though....