I want to install a triple gauge pod on the pillar. My question is if you did this install, where did you run the boost line through the fire wall? I would rather not drill, if all possible. Thanks for your help on this. Also is there a place to install a boost line other than a t fit into the boost line? I ask this cause I didn't have a boost gauge when I was tuned. I notice that paul from TT put a gauge in the window and ran a hose to the engine bay without cutting into any hoses.


-mike

 

I ran my boost line on my passenger side. There is a small hole next to the fender on the fire wall that will work fine, just make sure you have enough tubing.

 

Here is a link to the "how-to" section with pictures:

https://www.evolutionm.net/forums/sh...ad.php?t=98114

 

you can also go thru the fender on the drivers side. You can feed it thru to from inside the cabin and out the fender, under the hood. Hardly noticable.

 

Use the stock gromet like in the MRs

 

i used the stock gromet behind the pass glovy poped it out made the middle hole in the gromet a lil bigger and ran it behind the dash and up the a-pillar

 

I haven't looked into doing this on my Evo but on my Eclipse GSX I ran it through the steering shaft boot. Sounds like there are better options now though

 

thanks guys for your answers and help




-mike

 

I took a look at the steering shaft boot when I installed mine, and you aren't going to get crap by that sucker.