What do you all think?...i know it's a bit rough for now. But i'm hoping to find someone that can custom mold a piece that would look REALLy clean. This will have to do for now though.

 

That will probably turn out pretty dope if you are able to clean it up. Good job.

 

cleaned up that should be nice...

 

Thank YOu. I hope i can find someone to make a custom frame for the vents and the gauge. For now i think it will belnd in ok once installed.

Esp since i will be relocating the hazard flash like so:

 

Nice custom work, but IMO one gauge in the center looks kind of odd.

Nice Blackjack too.

 

...love it!

 

Its definetley different! Not bad though.

 

I want it to stand out....and be easy to see. I love seeing that little needle do it's thing!....brings me joy everytime i hit 3000 RPMs!

 

should look good when your done..

 

that a great idea.. points for being original

 

hm, I guess i'll just have to wait and see it on the dash. So far so good though

 

looks good bud. i got my whole panel done like that and i really like it

 

is that gauge kinda facing towards the driver's side, or is it flat.. if flat.. may be you should tilt it a bit towards the driver's side for better visibility.. but overall... nice job..

the place where you put the hazard is nice.. very clean.. good job..

 

Not sure yet on how i'm going to align it. I will have to play around with it once i tear up the dash to fit it in there.
Right not i have it tilted toward the back of the car on the vertical axis since the dash itself slants toward the windshield. I will have to work the whole driver slant later.

I will post up once i get it in.

Thanks to everyone for their comments. Hopefully it turns out well once fully installed. Just need some time to get into it. Schedule's been real busy lately.

 

Looks great!